high voltage spark tester

Test Voltage:1.0~15.0KV. Cable Diameter: 0~25mm. Output Frequency: 2.5-3.5KHz normal. Fast recovery time after fault (0.1s)

The Sine Wave Spark Tester is a fast and reliable instrument used in distinguish wire faults and detecting bare wires.

Its high-speed fault detection feature gives you prompt information without worsening the condition of the wire after the test.

The use of high frequency (3KHz) enables a traditional commercial power frequency bead chain electrode to be shortened to 120mm HS015E Model.

The Sine Wave Spark Tester is quality-assured to meet your needs.

Basic FunctionFast recovery time after fault (0.1 second).Occupies short space in line and with improvement factor of 50 compared totraditional CT power frequency electrode.Output voltage is 0.0-15.0KV (R.M.S.) adjustable.Test voltage is 1.0-15.0KV (R.M.S.) adjustable.Voltage Display: 0.0~15.0KV digit, 14.2mm LED display, Accuracy +/- 1% of readingOutput Control: Front Panel Reset in Manual Mode. Closure time is selectable0.2s/2s/5s in main board by jumper JP, Form C relay contacts (250VAC/5A) for allwire faults detected.Limits the fault current without damaging the test equipment.Short exposure time to corona does not degrade nor damage good insulation.Distinguishes all wire faults and detects bare wire.Safety Switch interlock.Basic Specification

Specification

HS015E Bead Chain For Cable

Output Voltage Test Voltage Cable Diameter Maximum Load Current Output Frequency Electrode lengths Fault Indication Output Control Input Control Operating Model Power Source Operation Temperature Operation Humidity Signal Cable Lengths Weight Dimension Controller          Gauge Head Line Speed

0.0~15.0KV R.M.S. 1.0~15.0KV R.M.S. 0~25mm 4mA Resistive,40mA Capacitive 2.5-3.5KHznormal Bead Chain 120mm Indicating lamp,Counting byDigital Counter 1 Form C relayContacts(220VAC/5A)forall wire faults and bare wire faultsdetected SP1, SP2 input interlock control Extruder ContinuousApplication 175~264 Volts, 180VA, Single phase, 50/60 Hz +4-45°C <90%RH 5M Control Unit =5 kgs, Electrode = 8.5 kgs. 360(L)x485(W)x90(H) mm 330(L)x200(W)x390(H) 2000 M/min. maximum*

*Follow UL 44, any point on the wire being traveled for not less than a total of 18 positive or

negative crests of the supplied voltage.

high voltage spark tester